View Single Post
Old 29th June 2020, 21:58
andysharrock's Avatar
andysharrock andysharrock is offline
Senior Member
Join Date: Jun 2011
Location: sheffield
Posts: 564
andysharrock is on a distinguished road

did the google bit and found the external dimensions of an mx 5 engine 600mm high from bottom of the sump too the oil filler cap. that should just hang passed the cross member by about 2" and clear the bonnet. the new wheels lift the car by a good 3" so the should cover the low sump. not sure about how the gearbox will fit tho but I should have the mx here by the end of the week so we will no if I need to get the grinder out again. today's works start on the floor I recessed the seat bit 60mm at the back but even before with the seat on a flat floor it was good for seeing over the bonnet and head height.




Reply With Quote