Quote:
Originally Posted by Patrick
Automotive artwork very clean.
|
Thanks, Patrick.
------------------------------------------------------------
Over the last two weeks I've tackled a rather random bunch of tasks some of which have taken a frustrating long time to get right but that's how it goes some times.
So in not necessarily the order I did them....
Accelerator cable.
The BMW accelerator cable didn't suit the Ford pedal so I cut the hook off.
BMW Accelerator Cable by
Sabrebuilder, on Flickr
To terminate the end of the cable I used this little clamp. It is very secure but I put a blob of epoxy glue on it before tightening it as it is so difficult to get to and I didn't want it falling off.
Accelerator Cable end by
Sabrebuilder, on Flickr
I could then install the Accelerator pedal.
Another Houdini act!!
Accelerator pedal by
Sabrebuilder, on Flickr
Steering column.
I've reinstalled the steering column and a Ford steering wheel that is IVA compliant.
Steering wheel and column by
Sabrebuilder, on Flickr
After years of searching I found a new lower coupling on ebay.
Steering lower coupling by
Sabrebuilder, on Flickr
I couldn't figure out why but, the mounting holes in the intermediate shaft needed to be re-drilled to get the alignment between the steering wheel and the steering rack correct.(I spent half a day trying figure out why and then decided to drill the new holes and move on
)
Steering intermediate shaft by
Sabrebuilder, on Flickr
Windscreen wipers.
I've mounted the wiper wheelboxes but the wiper motor drive tubes that came installed in the car were made of copper which is not recommended as the copper wears and can be noisy. I've ordered some new steel ones from SVC.
Wiper wheel boxes by
Sabrebuilder, on Flickr
It's nice to install the first small bits of chrome bling.
Wiper wheel boxes by
Sabrebuilder, on Flickr
Main wiring loom.
I've laid in the Sabre main wiring loom. The crimps in the white connector from the ignition switch, in the center of this picture, were very poor and I had to remake them.
Main wiring loom by
Sabrebuilder, on Flickr
Fuse box in the center of this picture. (BTW that's a polythene bag over the bodywork!!)
Main wiring loom by
Sabrebuilder, on Flickr
Loads more to do but all these small steps gets me nearer the end goal.
....peter