Having pretty much drawn a line under Barry's car , it meant that today I could get back to Ray's example.
I fitted the frame back on properly , first fit since painting it , bolted everything back as it was ....fitted his wheel adaptors and put his 15'' wires on .
I dropped it off the jacks and put the body in place for it's first trial fit ....
I need to remove the body , fit fuel tank etc and hopefully after a bit of a roll about the rear wheels will level up ...the front wants raising a bit as it's a bit low ...soft springs I suspect as they all get cut a similar amount initially ...
The body was pinned in place at the bulkhead and clamped at the rear to check frame fit / wheel arch centreing etc... and all is good ..little bit of fettling and alignment required on final fit but thats normal at this stage ....