Quote:
Originally Posted by seanick
I would consider plating the whole side, bending a flange on each edge to give you a channel section so you can weld onto existing doublers. Then you can prep a bit harder before you weld as the metal is thicker, up the amps a bit and get a stronger weld. Before the final fit either remove the old section or take out some metal with a hole saw so when you finally inject some waxyoil it gets where needed.
yrs, Nick
|
I'd love to do that, but have no folding equipment. And those outriggers are more than 24" and tapered... thanks for taking time to offer advice.
And i will up the amps!
http://garyssammiospyderbuild.blogspot.co.uk/