Fitted the framework and test fitted the body and had a little trouble getting the Drivers side low enough to cover the chassis side rail, I searched this forum and Trevors Blog scouring photos of how previous builds had gone.
I noticed that frames differ from build to build,
This is Daves frame (if i remember right) see how the top front rail is fixed inside the framework ,
This is mine the same rail is on top of the framework .
In order to drop the tub low enough the corners had to be fettled away ( read angle grinding frenzy) until it sat where I wanted it.
I am just about there with the position now.
Any one reading this before starting a build, I would recommend buying the ratchet straps - think mine were £10 for four, fitting the frame without them would have been nigh on impossible, they will be needed for holding the tub in place while fibre glassing too.