24th June 2022, 15:48
|
Senior Member
|
|
Join Date: Nov 2012
Posts: 845
|
|
More nibbling...
Time was at a premium today, so I only managed a couple of hours. Starting in the engine bay, I unclipped all the sections of the loom in front of the bulkhead and fed them through to the footwell. Before I could go any further I had to tear out the carpet, not that easy in places where it was attached with King Kong double sided tape . I then attacked the boot area, removing the lamp units etc. I decided to not cut the front to rear portion which runs under the seat bucket, but leave it in place for continuity testing - it might be good for re-use. The builder and/or subsequent owners certainly liked their reel of blue cable and the length of yellow/green domestic for earth!
I'm unsure whether to remove the seat bucket as I could well be making a rod for my own back. I'll have a good crawl about underneath tomorrow before deciding.
Regards, Mick
|