Mind The Gap - Part 2:
So a big batch of fibreglass filler was required to:
- Blend in the edges of the hollows.
- Fill in the small gap.
- Cover the fibreglass work on the driver's side.
Last job of the day was to sand this filler down.
Which did create a bit of a mess.
So with a bit of luck, I should be able to start the painting process on this side tomorrow.
Note:
The extreme corners of the frame/floor/arches still need to be sealed off.
But how I do that will be linked to how I extend the Spitfire wheel arches to meet the body shell.
I must confess I had hoped to get a bit more done today.
But this was still decent progress, as the "hard to reach" places are now taken care of.
So until next time take care, Paul.