Cheers for the quick reply's guys!
I probably should have put in my initial thread I know it's not a handbrake issue as the release mech works fine (already checked) and I have no preload on the master with full pedal travel.
I thought the preload was the problem ages ago as it seemed to go away when altered but this was not to be!
So the only parts I have left to change are the master cylinder and rear calipers which have full piston travel and brand new sliders!! However after reading some of the rover stuff it seems the sliders can sieze after no time at all and although mine has not done many miles it has been stood for nearly 2 years so I will have a look at these again!
I will let you know what I find
Ps I forgot to say that when the rears start to bind the brake pedal becomes extremly hard? would this happen if it was sticky calipers?
Craig
|