View Single Post
  #122  
Old 22nd April 2019, 10:48
thecarbuilder246 thecarbuilder246 is offline
Senior Member
 
Join Date: Jun 2009
Location: leicestershire
Posts: 320
thecarbuilder246 is on a distinguished road
Thumbs up chassis

Hi All

Sun out, wife out, tinkering time!
I've been out with the measuring stick again. I've took a point from the centre of the wheel arch on the cascu 246 and used some redundant gallows brackets after checking they were square. I've used my level to ensure they where upright and used packers were needed. I've measured across both the front and rear of the 246 shell. I've done the same with the deon shell but only at the front as I can't get to the back just yet without moving a gearbox,spare engine, engine crane and tig welder!!
Very surprised here as the are identical, both are 64 3/4 inches. If the back is the same then I think I'll backward engineer the deon suspension set.

ian
Attached Images
File Type: jpg 001.jpg (94.7 KB, 31 views)
File Type: jpg 003.jpg (94.3 KB, 26 views)
Reply With Quote