This afternoon and working together we offered the metal strengthening cage into position in order to mark out and drill the rear fixing stud holes through the inner rear wings to the boot. Easier said than done as the main tubes slide down inside the Z3 roll-hoop tubes but are an extremely tight fit!
Half an hour and several hundred thwacks with a soft-faced hammer later....
IMG_0770.jpg
After which of course we had the fun of removing it again
The rear left hinge in the picture is going to need to move if we're going to be successful in fitting the filler where I intend in the rear deck. Ian tends to get these cages fully prepped and powder coated before fitting too so it'll look a lot different further down the line!