3rd design set for the clutch bracket. As we ran out of ColorFabb HT filament it gave me a few more days to consider the design so I’ve revised some angles:
Mid print:
All 3 versions, note the middle one didnt finish printing:
Extra support structures
The first layer is a bit loose here due to gravity & the supports not quote hold it up - not an issue I'll trim those off as there's a lot more layers anyway.
Clearance for the fluid fill. You can see the layers don't look very smooth - that's by design as it makes the print stronger by having thicker layers. For a display piece we'd print with much finer layers that which would look a lot smoother. As this is a functional piece you can't see it doesn't matter.
Watch the print!
https://youtu.be/8UykB-97xgE