Rose Joint
Peter
excuse for jumping in on this, but i got mine from from ABC (Anglia bearing Company) part no. MP061F39 (male only available).However when i contacted them i had the last one, i tried to get an additional back up but it seems like they were manufactured specially (was it for Mike ?) as a job lot . I phoned round about 5 other specialist companies and basically the answer seemed to be that no one did a 3/8 UNF male thread and a 10mm rose joint hole.
Mike may have better answers. I had to have a collar machined up anyway to join the male joint to the servo push rod thread. I found in my Marlin i had to shorten both the rose joint thread and pushrod thread length slightly to get them to fit and still have a decent amount of thread in the collar. So there is no reason the collar could have different threads at each end 3/8 facing the servo and 10mm to meet the male 10mm rose joint.
Nigel
|