View Single Post
  #19  
Old 31st May 2019, 12:32
Bellicose Bellicose is offline
Member
 
Join Date: Feb 2019
Location: Essex
Posts: 56
Bellicose is on a distinguished road
Default

Wheel Arch Lip & New Top Line

So, this weekend gone I managed to get some time to work on the car.

I cut out a new rear wheel arch lip from 12mm MDF, I then welded 80mm supports all round the existing arch to get the new wide arch projection. I'll be gluing the mdf to the metal support.

Once that was done I decided to see how the lines of the new car would be by putting masking tape from the arch lip to the new top line I made a few weeks back.

It looked shit lol



The angle sloping up was all wrong and the line once it got there was terrible. So I had to take the decision to get rid of the top line and create a new one.

So I cut it off and then did the same tape experiment going to the original body. Well it wasn't far too where I wanted it, just needed to be an inch further out. So following the existing car lines I extended out by an inch. This left me with this line





Much better, once shaped with a slight curve it will look spot on how I have designed it.

Next job is to remove the rear bumper and roll over protection then I can continue with shaping the rest of the new body.

Last edited by Bellicose; 8th June 2019 at 22:29..
Reply With Quote