Thread
:
Up-dating my McCoy
View Single Post
#
102
25th February 2016, 17:23
pompeyal
Senior Member
Enthusiast
Join Date: Jun 2008
Location: Fareham, Hants
Posts: 161
Bonnet continued
Marked out position for the latch pin interface plate and bonded into place using epoxy resin and coated top surface…
Positioned the hinges onto the car and measured the distance between the holes…
Placed hinge interface plates into position, measuring from the centre of the bonnet and checked hole positions, then marked their positions onto the bonnet..
Applied the epoxy to each of the interface plates and bonded into place checking between the stud centres and applying the epoxy to the top of the plates..
Checked the fit of the latch pin and now wait for the adhesive to cure.
pompeyal
View Public Profile
Find all posts by pompeyal