Hi Craig
I am building my MX250 at the moment as well and come across the same problem of the front end sitting to high. I have based mine on a MK2 body and ended up cutting the corner supports off and reglasssing the corners back in at a smaller dimension so that it sat lower and also had to cut out the corner of the light support to miss the headlight buckets.
I then made a bracket to pick up the front brace in front of the radiator to bolt the front end to.
Have attached some photo's of what I have done and how low I got the front end although the last photo is upside down as I took it with my phone and can't seem to rotate it round.
Nick
|