Hi just an update. Axle mount being made using 50x50 box and 25x50 box in 3.5mm, also diff plate in 6mm. Set ride hide to chassis at 18.5 inches. Tyres will be 224/45x18s so will give an extra .5 inch lift at rear. Mount partly made up just got to do shock mounts and bottom plates so it will sit in chassis frame. drill mounting holes in chassis frame and axle mounting frame so that it can be unbolted and dropped out at a later date if needed to be worked on. Another couple of days working out and weld cutting etc, don't want to rush. Measured up for prop so can get that made up ready, have at look in CKC mage for prop firms, hope to have next week. Then measure up diff tie bars and outer radius rods. Ho Hum still its winter and cany use car at mo anyway.
Any way here are some more pics, anyone one with ideas views etc welcome to respond, good or bad.
http://s1342.photobucket.com/user/Ba...%20install%203