Hi, Looking for ideas and suggestions on wheels.
To start discussion, I quite like these from XXR (553). However, they are quite wide and not sure they will fit in the front wheel arch?
If I calculate correctly , they will protrude 81mm from the hub (8" = 203/2 mm - 21mm offset = 81mm) and most other builds are around 70mm. So is it too much?
Should I go 15" or 16"? I think 16" will look better but am worried about a harsh ride as I have lowered the car.
At the rear I calculate I would still need a 45mm spacer.
Or what else could you suggest? Are there any good designs with staggered offsets?
