So back to work today and just in time as I think the other half has cottoned on to that all our day trips end up in the same place.
So after a few hours on the beach, we just happened to stumble on the Tribute workshop and I managed to get another hour on the beast.
Early evenings are a good time to play with filler and I didn't waste any going hard before I used it.
So starting to look at the near side, I realised my bonnet bulge is not a symmetrical as I would like so I added filler to even it up a little but I haven't blended this in yet as I was running dangerously low on filler.
The main job was to cut in the other headlamp panel and stitch it together.
Its too big of a job to complete in an hour but its in place and next time the long process of blending the panels and creating the curves can start.