View Single Post
  #43  
Old 26th May 2018, 17:35
lancelot link's Avatar
lancelot link lancelot link is offline
Senior Member
 
Join Date: May 2009
Location: POOLE , DORSET
Posts: 2,200
lancelot link is on a distinguished road
Default

Just over 4 hours at the workshop today of which 3 were spent on Ray's car ...

I tied in the inner arches to the rear of the bulkhead and bonded them to the rear outrigger / frame area as well .. I used aluminium as its a nicer join if ally meets ally ..
I also made a little body tie bracket that was bonded and tecscrewed to the end of the outrigger and bonded to the inside of the body holding the end of the cill in place , blanking off that open end and also another fixing point for the rear bulkhead ..





This whole area will be finished in a black underbody coating like schutz or similar , so will all blend together nicely ...

I finished off by making a start on cladding the centre console between stick and dash ....the area all the switch gear is going to live ..this is rivetted in place ...



tomorrow I will clad the tunnel sides and start mapping out the top surface as well ....

Last edited by lancelot link; 26th May 2018 at 17:52..
Reply With Quote