Not much in the way of pics but getting close now!
1. Chased down an annoying small collant leak, it was the o ring on the bottom rad drain that had perished, new o ring and bobs your uncle.
2. Rear number plate finally fitted.
3. All rear lights are now wired and tested, just got to fit the one lamp cover and I will post some pics.
Next task is to give the inside a good clean out then top up the gearbox and overdrive oil and run 2 wires for the overdrive switch and then the tunnel cover can go on. Once that's done the interior will get its final coat of bed liner I preparation for fitting the seats.
Bonnet should be on tomorrow
just waiting on a throttle cable pedal block and I can then fit the throttle cable which will make it driveable.
TTFN
Mac
|