Parts arrived back from the anodizes but i must say i prefer to see the bare machined ally finish, it just looks better.
IMG_6356.jpg
Made a little progress this week with the seat belt brackets.
IMG_6360.jpg
My thought is to bolt through the top box section behind the rear bulk head, welding in crush tubes for the bolts to pass through and bolt to a 10mm spread plate at the rear of the box section, this way i hope to achieve maximum security in the event of a collision. The section where the belt passes through has a 3mm chamfer to prevent any chaffing of the belts when in use.
IMG_6358.jpg IMG_6359.jpg
Bracket loosely in place above the seat, its looks to be the solution but i will know better once the inertia reel is fastened to the lower box section near the floor, need to make sure there's enough belt movement before the back catch meets the ally bracket.
Well that's it for now see you all soon.