chassis
HI
Yes the dax chassis would have the engine the 'wrong end'. It was just an example of a simple ladder type chassis similar to the dino one. What I liked was dax's camber compensation arrangement at the front instead of an anti roll bar.
The other chassis with the 'engine the right' end was from a vortex. I was mulling over adapting one of these as I know where there is one for sale.
I had looked at pie valley chassis's after they were featured in which kit magazine but they use either beetle donor parts or mg and neither fits in with my design.
The original chassis I have is built from small 25 x 25 and 40 x 40 box section with 1mm flat plate. It has high cills and a huge centre /back bone which I want to remove as I want a more authentic cockpit. see attached
ian
|