If you see my last post I am now happy the the cut up front panels will all work well so I have taken them off again to finish what I call the front structural bulkhead.
[IMG]
[/IMG]
From inside the car sides of tunnel being formed all square, plumb and level. All pinned and glued.
[IMG]
[/IMG]
From inside the bonnet plenty of room behind the engine, may use as secure glove box accessed from the cockpit with a little more ply under the bonnet.
I will now concentrate on the outer side footwells and then go to the back bulkhead behind the seats and get all the ply work done before I start to fibreglass.
I also have to reduce the floor pan where there was a hump under the original drivers seat.