View Single Post
Old 22nd August 2019, 20:37
Mitchelkitman Mitchelkitman is offline
Senior Member
Join Date: Oct 2013
Location: norfolk
Posts: 586
Mitchelkitman is on a distinguished road

Were you successful with the headlight bowls? I've only just seen the subject, so have arrived 'late to the party' It would be possible to make a GRP female mould off a plastic headlight bowl, add a flange (say, 1/2 way if that makes sense) and do similar with another mould for the rearmost part, so that the 2 halves can be screwed together from the rear.

Last edited by Mitchelkitman; 23rd August 2019 at 16:35..
Reply With Quote