[Mick O'Malley]

Digging out my Machine Mart aircraft quality tin snips, and searching through my scrap metal heap, I assembled the necessary, made a cardboard template and cut out two fishplates. I'd intended four but decided that was overkill. I drilled their rivet holes and G clamped them to the box section. After carefully and very lightly centre punching the box through the holes, I drilled and rivetted them in place. All that was then left was to remove the cross member and dangle my creation from a length of the ever-useful paracord for a photo-call.



I'm now reasonably confident that with its easily manipulated assistance I can accurately fabricate mountings. It's certainly considerably less unwieldy than the engine it represents!

Regards, Mick