Good news.
The new servos have arrived, and certainly look good finished in Powder Coat Paint black. They are almost identical to the unit we tested, so I will go ahead with the main order on Monday.
I have posted pictures of the servo below, as this is your last chance for any changes of mind - would anyone like a powder coated one in preference to the ordinary Zinc unit for just £10 extra. I'd say it is certainly worth it.
The adaptor plate is a trial of one laser cut - the quality is superb. The universal plate will only have one set of holes to fit the servo. You can then drill yours to suit whatever angle your master cylinder requires. I'll get a circle etched at 70mm which equals the Metro/Ford fixing centres to make it easy to establish your drilling points. (or of course you can ignore it if it does not suit)
Unless I hear from anyone over the weekend I will order as per the list on the Forum.
With a following wind it is still possible you could have them for Christmas!
Regards to all
Mike