Thread: deggsy's A352
View Single Post
  #424  
Old 22nd October 2019, 19:27
deggsy deggsy is offline
Senior Member
 
Join Date: Mar 2015
Posts: 395
deggsy is on a distinguished road
Default

I made some alloy strips from 1.2 alloy sheet and shrunk them to shape the first un-drilled one i shrank too far and is useless three attempts later I managed to have two good ones.

they will look a bit like this when finished

I found some alloy effect edging but it wouldn't bend around the curve at the rear top of the perspex so I had to angle them like this.

Not sure if its better or worst any opinions?
Reply With Quote