Thread
:
Up-dating my McCoy
View Single Post
#
64
29th November 2015, 15:16
pompeyal
Senior Member
Enthusiast
Join Date: Jun 2008
Location: Fareham, Hants
Posts: 161
Bonnet continued..
I have cut out 5 ribs and marled out the curvature across the car and cut the profile on each
Then the plug was marked out for the fixing positions then drilled and assembled
When all attached the whole thing was placed onto the car and using brackets and blocks, it was set so the profile was at an equal height off the car
After that I pulled the plug down onto the brackets and then from the underside I made brackets to lock the whole thing to the car, then a coat of primer to seal the MDF in readiness for shaping the sides and front of the bulge and once done I will put a small radius around the edges in readiness for the gel and glass.
pompeyal
View Public Profile
Find all posts by pompeyal