Another thing I'd like to check - my clutch slave cylinder is fitted with a plastic pipe instead of copper one, so the connector attached to the slave cylinder does not have a nut/bolt thread.
IMG_2105.jpg
IMG_2113.jpg
IMG_2115.jpg
I am planning to use a new flexible hose in between master and slave cylinder copper pipes using a rubber break hose.
Am I right in thinking that I can remove (unscrew) the plastic pipe connector from the slave cylinder and screw a new (short) flared copper pipe with the fitting directly into the slave cylinder?
IMG_2110.jpg
IMG_2109.jpg
So much for now.
Cheers, D.