View Single Post
  #2026  
Old 7th September 2015, 09:44
andrewhush andrewhush is offline
Senior Member
 
Join Date: Sep 2011
Location: Stanley, Durham
Posts: 104
andrewhush is on a distinguished road
Default

To make levelling easier I made up some rigid replacements for the spring/shocks using some 20x40mm box section I had lying about. That way you can set the suspension geometry to whwtever height you choose and it won't move when you drop the body on. To cope with yor sloping drive, mark where the wheels sit on the ground then move the car out of the way and make up some piles of ply packing up to a common level at the marked positions. Then move the packing piles just far enough to allow the car to be rolled back to where it was before, jack up and insert the packing.

Last edited by andrewhush; 7th September 2015 at 09:46..
Reply With Quote