Flying G46
We are currently working on the door cills, nice to see another body so we can compare, its looks as yours is identical to ours where the drivers cill is a lot deeper and tucks under more than the passenger side.
As they have to be cut it gives a lot of scope for modelling them to suit the individual car, we are making a recessed section down each side to take cherry bomb exhausts, proving a little bit of a challenge but getting there.
We found the roll over bar just got in the way and ended up chopping it off so we could line up he body.
If you go to our very first page on our thread we posted a few photo's of the body cutting up which may assist as did WCA or should I say (hop along) WCA was definitely the right handle for him!
|