Having considered a few options for the wing stays I finally decided to make my own. I wanted a design that was light and stiff. didn't require any welding (in my experience welding is nearly always the weak spot of any wing stay), was easlily adjustable and didn't cost a fortune.
After a lot of head scratching I came up with this. It fulfills most of he requirements! There is a tiny amount of "woibble", but far less than the Marlin and it cost less than a tenner!
DSCF2096 by
Robin Martin, on Flickr
DSCF2100 by
Robin Martin, on Flickr
Cheers, Robin
Electrics next!
Threaded Mode
