Project BadRep - Another MRS200 build

[Badrep]

Thanks for the kind words guys!

Nostromo - I made that mistake on literally every panel I upholstered!

Most of the work has come together since Christmas - before that it was quite slow and mainly roll cage, hence the big gap in update - it just looked so samey to keep the updates coming! The big moneyshot was really in the last 2 weeks!

[Paul L]

Badrep - As others have said, your 3D printing work and the interior in general is setting a very high standard.

Good luck, Paul.

[wozzy]

Great work

[Badrep]

Thanks Guys!

Small update, engine is in, driveshafts back in place, all crossmembers, arms, and exhaust are back in place amking the car mobile. All I need to do is put the wheels on, bleed the brakes and clutch and get out the garage. Then I can start on the body finally!




There's also a nice amount of space for a turbo here (hehehe)

[Nostromo]

Looking good buddy! Tidy job. That's a 2zz? Nice clean looking sub frame down there too. Apparently they have a very bad habit of eating themselves from the inside.

It might be worth your while getting that enormous air filter out of the engine bay a bit.

[Badrep]

Originally Posted by Nostromo

Looking good buddy! Tidy job. That's a 2zz? Nice clean looking sub frame down there too. Apparently they have a very bad habit of eating themselves from the inside.

It might be worth your while getting that enormous air filter out of the engine bay a bit.

Haha - the subframe has been cleaned... but it far from clean - I didn't bother painting it as I think I'll get a replacement!

Yup - it's a 2zz. I'm hoping to turbo it over the winter as well so should go like the clappers when done

[Badrep]

Finally had a chance to clear the garage (LOL 'clear' the garage!) and get the body on in it's mocked up position.

Still on stands:





Then off the stands, maneuvered into a better position and the body placed on top.













Things are going to get exciting soon!