Originally Posted by EXI Turbo
Hi, I am building the turbo version and would like some advice on the brakes. Currently all I have is the rover Servo and master cylinder so need to buy the rest of the braking system.
Any recommendations ? I will be using the car mainly on the road but plan on a few track days.
Here is my setup. Though not on the road, brake seem to stop on a six pence.
Servo from 220 Turbo.
Master Cylinder from a 216 bubble I think. This was to get the outlets on the right side for the Marlin supplied pipes.
Marlin supplied braided hoses.
220 Turbo front calipers with standard drilled/grooved disks and EPC green stuff pads.
Rear 220 turbo calipers and drilled/grooved disks and EPC green stuff pads.
Handbrake cables for a 200 bubble. Not sure with as there are 2 different sizes I was told. But went for the longer of the set.
After speaking to the guys on here, I will be changing to just grooved disks.
You will also need to space the carrier bolts with washers.
Hope that helps.