Bodywork....Ahh!!!!!!!!!!!!!
Hi...
Having a nightmare at present. Bodywork is being a pig to fit.
Front and scuttle seem ok now but main problem area is the joints between rear clamshell closure at bulkhead and the inner side panels to rear clamshell near the roll cage uprights (if this makes sense)
Only way I can see of getting it to fit is to drill a hole in the top horizontal plane of the inner side panels at the rear bulkhead and inserting a screw to pull down the inner side panel to match the angles on the rear clam. (with suitable packing underneath.)
Anyone else had this problem / solution?
Thanks
Rich
|