Mike, Keith and Davecymr thanks for the support. Nothing much to update as I have been away for the new year in Ireland with limited internet and not back to Yorkshire till Monday.
But I have come up with a plan for the front grill whilst been away so will try and fit that on Monday.
Keith I could use the contact you have for wire wheels painting when you get chance please.
Davecymr the garden lockup I think I am safe till March I wasn’t brave enough to use the summer house lol, thank you for the garage comments still work in progress after 3 years but my first garage build and design.
Mike once the lights are in and working I think it will be time for a trip out in the alpha.
Mike, Keith and Davecymr thanks for the support. Nothing much to update as I have been away for the new year in Ireland with limited internet and not back to Yorkshire till Monday.
But I have come up with a plan for the front grill whilst been away so will try and fit that on Monday.
Keith I could use the contact you have for wire wheels painting when you get chance please.
Cas Coatings, ecleshill, must be near you!
Davecymr the garden lockup I think I am safe till March I wasn’t brave enough to use the summer house lol, thank you for the garage comments still work in progress after 3 years but my first garage build and design.
Mike once the lights are in and working I think it will be time for a trip out in the alpha.
Well after a long trip at work and a holiday I am back on the Alpha. After a catch-up on the forum that took a while it’s nearly 2 months since I last looked.
Keith thanks and yes cas coatings is the one I used.
Micky1mo time is getting short for the summer but I am determined to have the Alpha on the road this summer.
So I pushed the Alpha out to have a look in daylight.
I am still not happy with the front wheel arches for the clearance of the arch around the wheel. I know the car was originally made for 14” wheels and I had
fitted the bonnet slightly higher at the front. I decided I have to get this right. So back out with the foam tape rule marker and grinder.
The next few photos show me modify the front arches again.
The arches went much faster this time and not many plastic clothes pegs were harmed this time lol.
This just left me time to start adding filler to fibreglass.
So with a bit of luck or good time management I should get to fill both arches tomorrow and smooth off.