MadaboutKitcars

Hi All,
Hope to fit the side panels this week and was wondering if anyone has devised a cunning plan to allow the inner wheel arch on the passenger side to clear the heater blower. Looking at the build manual they seem to have just hammered the panel to make a bulge but this looks like a bodge to me.

Regards
Mike R

Hi Mike.

If you look here, this was my solution (third picture down):

http://www.delta-sin.co.uk/johns-5exi/build9.htm

HTH

Cut hole.

Bend metal and seal. Fix using two rivets.

Seal top and bottom with trigular cut ally and seal.

I have a bigger digital image if that helps.

Mike

I set about my heater with a hackswaw and took as much off a I could, seemed to work ok.


Steve

Hi Limpabit,
Your solution looks very neat - a bigger digital image would be appreciated.

Regards
Mike R

Hi Mike.

PM me your email address and I'll send you over a copy.

Cheers

John.

I found the best solution was to bin the Marlin white joining panel, and make my own from an aluminium plate. With that done, mine fits milimetre perfect.

I Just reduced the overall length of the heater box so it fit with in the constrant of the bulk head panel by cutting the heater box and making my own ally plate to fit it
I will have a look at my pics later and email them if that is any help

Jerry

I've ended up cutting the side panel and making an extension piece to cover the protrusion. Thanks

Mike R