This is a read-only archive of the old Madabout Kitcars forum. New posts and replies are no longer possible, but every thread is still here to browse and read.
The bushes have a habit of wearing out under stress so if you have to buy a new set, a better quality plastic may be a good option, I know Tony was heading in that direction although i think he had identified they are not an off-the-shelf size!
I have a 1/2 set of spares you could borrow to get you building but I would want them replace as spares for my car when it gets to the point of being stressed.
I also have some ball joints I do not need as I have changed my rear uprights and fitted all the same type.
I think you will find that there are differrent sizes but I am sure someone will know what the Motor Factors need to identify them.
I also have the gear change assemble complete (cables, rods and shaft)and a clutch cable I have no use for, set of 14" wheels, exhaust manifold, heater box and controls and a shed load of other Rover stuff, full PAS and rack, servo and master cylinder, pedel box to mention a few....
I could get them too you at no cost next weekend as we will be at a track day with my son (31st Hullavington). He could then drop them off as he lives in your area.