Skip to main content

MadaboutKitcars

This is a read-only archive of the old Madabout Kitcars forum. New posts and replies are no longer possible, but every thread is still here to browse and read.

Laser Cutting / Water Jet Cutting

GreatOldOne 24 Jul 2009, 11:54am
Guys,

I want to get some stainless steel rings made up to act as accent pieces for the rear lights on the Gooster. Does anyone have any experience in getting parts laser or water jet cut? Where did you get it done? Where you happy with the results?

I have the dimenisons of what I want (They're just rings, 140mm ID, 150mm OD), but I only want two of them - so a lot of the local companies round here aren't really interested considering the low volume.

Any suggestions would be welcome

Ta,

GOO
splitybus 24 Sep 2009, 6:16pm
What gauge material are you thinking of?

I get alot of stainless and mild steel laser cut but it may depend on the thickness you are after?

David