This is a read-only archive of the old Madabout Kitcars forum. New posts and replies are no longer possible, but every thread is still here to browse and read.
I need to get this part made up (rear grille/numberplate holder). I've looked at the IVA regs and I 'think' I'll have to have a 2.5mm minimum radius of curvature everywhere. I was really hoping to avoid this for cosmetic reasons . Can anyone confirm from personal experience if this is correct, or can I get away with a 0.5mm mroc?
. Can anyone confirm from personal experience if this is correct, or can I get away with a 0.5mm mroc?
