Skip to main content

MadaboutKitcars

This is a read-only archive of the old Madabout Kitcars forum. New posts and replies are no longer possible, but every thread is still here to browse and read.

problem with Rebody form for DVLA

Car photographer 7 Jun 2016, 11:10am
Hi everyone,
so I'm just about to start filling out the rebody form to send off to the DVLA - but on the form there's not a seperate row for chassis and bodywork - they are both on the same row ... so what should I do - obviously I'm changing the body but keeping the chassis, so shouldn't I really need two rows for this? (see yellow section in attached pic)

any advice?

thanks

DVLA by paul ward, on Flickr
oxford1360 7 Jun 2016, 1:14pm
I think the slash is an "or". Hence your chassis no. is ........

You don't have a "Bodyshell" or monocoque. They are not referring to a removable body.
NeilF355 7 Jun 2016, 1:56pm
For my 250 GTO replica on a Porsche 944 donor I put the donor car Vin number in the Serial/ ID column as my donor car has a monocoque body and no chassis.
I also added the engine number in that column but left the others blank.

The origin column I filled in with the donor car registration for each row.
Make of component was Porsche in each case (even though Porsche seem to use quite a few parts from VW!)