This is a read-only archive of the old Madabout Kitcars forum. New posts and replies are no longer possible, but every thread is still here to browse and read.
i have spent some time on the kit those last days.
When playing with the headlights bowls, i noticed that they don't fit directly ( MK1)
So , what is the best way to handle this.
Cutting the edges ( like with the impact bar) could make the front end weak ?
Should i then make some reinforcement plates ?
Hello, i have changed the titel of this post.
This way, i 'll post all my question here.
So here we go :
I think i soon will be able to glue the rear part of the kit.
I noticed that kit is very flexible ( for example when you push on the fuel lid to open)
So , is it ok to inject some expansive foam to fill the gap between the kit and the original body of the car ?
Make sure you seal it well if you do. I filled the arch gaps in mine and then fibre glassed them in but the foam will hold water if it gets in and give you rust on any metal. I ended up having to dig it all back out again.
There are two types of foam. The Fire Rated foam is closed cell, in other words it will not absorb water. Use this one.(mousse coupe-feu in your local diy store)
Do not use the normal type as above as it will hold water, as fatbloke experienced.
