Rear suspension top mountingpart
Hello there,
I really hope we can help each other on this forum; I'm also building a Marlin Sportster, but mine is Ford based. I use a lot from the scorpio cosworth 1991 model, especially THE ENGINE itself ! My question to you, the BMW based ones: The rearsuspension should be a sierra or scorpio damper for me, but I was lucky to get an air-compressor assisted set from a BMW. Now my problem is that I don't know how the top-part looks like. I have a part that on the left and right needs a bolt through it, and front and backside (compared to driving direction) have a hole to put a bolt through for the topeye of the damper. The BMW damper has a thread itself, instead of an eye like the Ford-one. Does anyone of you have a picture of the BMW part? Please email it to me, or discribe how it looks like. Otherwise I must improvise myself. PJC |
Rear Dampers
Have a quick shufti at my website - there are a couple of pics of my dampers on there from a BMW 325 E36.
Andy www.marlinsportster.co.uk |
http://www.e30shop.de/ does replacment top bits (technical term ;) ) here the pic from their site:
http://www.e30shop.de/domlagerhi.jpg |
Here's the ones from mine if you still need pictures :) :
http://www.msportster.co.uk/data/TN_construction11.jpg Top mount - bolt in the middle holds the damper into the top mounts and the two little ones next to it hold the top mount in. I used a mole wrench to hold the damper still so I could undo the bolt holding it. http://www.msportster.co.uk/data/TN_construction09.jpg Old top mount next to the new one. The part is actually from an E46 convertable (as recommended by some one on E30zone.co.uk :) |
All times are GMT +0. The time now is 07:57. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Copyright Madabout Kitcars 2022