250 Build
5 Attachment(s)
Just starting my 250 build. Base car is a tatty 2.8 Z3
Going to dye the carpets and fit Rover 75 seats It will be a long build as don’t have much spare time |
Good luck with the build.
And welcome Dave |
Thanks Dave
|
Welcome, all build threads are avidly read on here.
|
Carpets
1 Attachment(s)
Usual Z3 problem. The sponge Under the carpets was wringing wet and carpets were stained and a nasty beige colour. I decided to take them out, power wash them and then try and dye them black. Really pleased with the results.
|
Quote:
|
Rover 75 seats
Hi guys
I’m putting Rover 75 seats in the car and have just losely placed them in, but they are very snug!! The switches for the electrics touch the side of the car!!! Has anyone hear had a similar problem and if so how did you get round it. Thanks |
I think people fix the controls to the bottom front of the seat with cable ties
|
I decided against the Rover seats as they are just too large. I am going with MGB seats fitted to the original bases. Others have fitted later MGF seats and they look very good, both are that much smaller than the Rover seats but the Rover seats have that advantage of cost.
|
Quote:
Thanks |
Quote:
Thanks for the reply though |
I fitted MX5 seats but had to make up square section bracket that bolted straight to the car floor using the existing fitting for the BMW seats, very comfy with plenty adjustment if your tall. Good luck with the build.
Trev |
1 Attachment(s)
I have found these on evilbay. May work a treat with some flat bar to adapt to the Z3 mounts.
|
Guage pod
2 Attachment(s)
Started to cut the dashboard up to fit the pod in today, very happy with the results. Bit of filling then painting the whole lot black.
|
Quote:
|
Quote:
I am going to weld some extra bracket for my rover seats. I am only 5 feet 5 inches and wife is smaller so seat height is ok Thanks |
Quote:
Thanks for the reply |
Gauges Here
1 Attachment(s)
These are a work of art😁
|
Have you bought a set of instruments?
If so a detailed step by step guide with a wiring diagram would be a great addition to the site. I am very tempted to buy a set when funds allow but the wiring frightens me. |
Quote:
Thanks |
All times are GMT +0. The time now is 20:42. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Copyright Madabout Kitcars 2022