Madabout Kitcars Forum

Madabout Kitcars Forum (http://www.madabout-kitcars.com/forum/index.php)
-   Phantom GTR/Vortex Builds (http://www.madabout-kitcars.com/forum/forumdisplay.php?f=14)
-   -   front wheel bearings (http://www.madabout-kitcars.com/forum/showthread.php?t=3164)

grahamhughes 17th November 2011 15:06

front wheel bearings
 
hi all
does anybody know which front wheel bearings i need to fit to the hub and bearing housing supplied by vortex. Chris at vortex told me to use the bearings from a MK2 mondeo. I ordered them which were delivered to my local garage but they dont fit. The outer is to big to fit into the bearing housing and the centre is also too big for the hub
Regards graham

EddyP 8th December 2011 17:10

Graham - I think you've spoken to Chris about this already, are you sorted now?

grahamhughes 8th December 2011 17:51

Hi Eddy
Yes am sorted now. It was the mondeo mk3 front wheel bearings that i needed but the wheel bearing housings supplied by chris were wrong, they were 2mm oversize. Chris has supplied replacement ones and the chassis is now sat on all 4 wheels with the engine/box installed
Regards graham


All times are GMT +0. The time now is 01:18.

Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2021, vBulletin Solutions, Inc.
Copyright Madabout Kitcars 2014