Mac - Great job on the gearbox cover. :cool:
Obviously the next thing I will be looking closely at is the small "bridge" section that joins/seals the cover to the hand brake panel. Good luck, Paul. :) |
Just seen your finished gearbox cover mac! I really like that, it looks the part, very smart.
That gearbox cover they sent you was not a GT6, as they are identical to the Spit. I've never seen one like you had sent, but you've certainly got round that one in a good way |
Gearbox tunnel looks great Mac, adding the extra colour will change the look of the interior for the better.
|
gt6 gearbox cover start/ motor on right .... car's looking great mac
|
Cheers Phil, whatever it is it fits and looks ok.
Just finished a few more jobs before putting the seats in. 1. Moved the fuse box as it was hanging down too far. 2. Cut an access hole in the dash to allow access to the fuse box 3. Touched up the bed liner in the foot wells. 4. Made a bracket to mount the fog lamp on the rear. its in primer just drying in the sunshine outside and will get a few coats of body colour in a minute. 5. Decided I didn't want to leave the rear of the seats in bare fibreglass so have just stone shipped the back of the first one. 6. Final fixed the runners to the drivers seats and cleaned and greased them. Had to modify the operating hand quite a bit as they are a lot closer together than they are designed to be. Pics: Seat before and after stone chip. https://lh3.googleusercontent.com/-J.../IMG_02215.jpg https://lh3.googleusercontent.com/-Q.../IMG_02216.jpg https://lh5.googleusercontent.com/-e.../IMG_02217.jpg https://lh3.googleusercontent.com/-G.../IMG_02218.jpg Think it looks much more "finished" now. Daft really as you will very rarely see the backs! Pics of the runners on the drivers seat. you can see the other operating handle on the floor which give an idea of how much it had to be narrowed. https://lh6.googleusercontent.com/-O.../IMG_02219.jpg Fog lamp bracket, just about ready for top coat. https://lh3.googleusercontent.com/-f.../IMG_02220.jpg That's it for now, more a bit later hopefully! TTFN Mac |
And here it is a Ribble Navigator in its natural environment!
https://lh5.googleusercontent.com/-_.../IMG_02222.jpg https://lh5.googleusercontent.com/-Z.../IMG_02223.jpg https://lh3.googleusercontent.com/-F.../IMG_02224.jpg https://lh5.googleusercontent.com/-g.../IMG_02225.jpg https://lh3.googleusercontent.com/-h.../IMG_02226.jpg And for the doubters I'll public the most rubbish first drive video ever taken when i get home to prove I didn't push it out there! |
Well i wasnt joking definately the worst ever first drive video ever recorded! But it was genuinely the first drive!
https://www.youtube.com/watch?v=svH9gX90WfY TTFN Mac |
Nice,car looks good:music:
You've put stone chip on the back of the seats,does'nt this get soft and sticky in the sun? And you were right,very bad video of a steering wheel.............. |
Mac - Congratulations on your first drive, the paint looks great in natural light. :cool:
It might be the angle of the photos, but your twin tail pipe look lower than mine and seem to stick out further too. ( Don't get me wrong, I think they look good. ) What is the tape on the passenger side for? Looking forward to seeing all the last finishing touches in place. Good luck, Paul. :) |
Rene, Thanks. The stone chip is fine its not like underseal and dries with a hard finish. Its had a coat of gloss black on top as well just to make it look a little nicer.
Paul, The exhausts are definitely low! I may revisit them at some stage but there staying there for now. The paint does look better in daylight. The tape is an idea i was working on as i found a couple of paint blemishes on one side that i will have to touch in or the other possibility was to turn it into a two tone paint job by doing the taped out are in something like a cream colour.....havent decided. TTFN Mac |
great looking car looks really well.will look spot on when fully finished, not long now until the wide open road.
|
Well done Mac, the car look terrific!
|
I have to agree with everyone, great looking car! I loved the video too, proof is proof no matter how wobbly:high5:
|
Wot, no video? :popcorn:
PS, it will cost you another tenner if you ever take it on a ferry, just for the exhausts!!! |
Just watched the video.
Very well done, the car looks and sound stunning.:rockon: Your only problem is what to do with your spare time now it's completed. :laugh: |
Very nice that man! fingers crossed for a quick re-test and then out-n-about for summer! :)
|
Good luck with the retest, car looks the biz. :)
|
That's a great looking car Mac, well done but what's the next project.
How did it drive on the road? How's does the suspension perform? |
Quote:
Well done, your car looks terrific. |
All times are GMT +0. The time now is 15:03. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Copyright Madabout Kitcars 2022