22nd November 2023, 13:09
|
Senior Member
|
|
Join Date: Nov 2012
Posts: 845
|
|
Today, time being at a premium, I was only able to address some of the filler relocation jobs. A first attempt at cutting through the rear deck with the padsaw proved both awkward and tedious, so I used the 'ring of holes' method with a 3mm bit, joining them with a short and super slim padsaw blade which I made by cutting down an old hacksaw blade with tin snips. Five minutes later - job done. I then dropped the 2" tube through the hole and, aligning it accurately, marked where the hole in the top of the tank would need to be cut.
I removed the tank and tidied up, the metal cutting being left for another day.
Regards, Mick
|