Tonneau
Does anyone have any pictures of the Sportster tonneau? I just received mine from Marlin and there doesn't seem to be any cut-out at the back to take into account the roll bar. I could just be being a bit thick but there are no instructions for fitting which doesn't help.
Also the centre zip is fitted at an angle so that it starts at the centre at the back and then angles towards the drivers side. By the time it reaches the front the panel is only about 12 inches wide. (I will post a picture later) I am sure there is a reason for this but I can't think what at the moment.
On the plus side it looks well made and is supplied with good fixings (lift-the-dot rather than the cheaper press stud things you sometimes get)
Robin
|