Collecting the body spurred me on to do a bit to my chassis,
So far I have stripped the left rear suspension right down, wire brushed to bare metal and repainted each part.
I overhauled the brake cylinder replacing piston, seals etc.
Started to wire brush the chassis back to bare metal and then paint using hammerite.
Cannot reassemble until I have the new polybushes, and I want to fit the Spitfire swing spring .
Diff is out for clean up and replacement of all seals.
Will only strip one side at a time so I can reference it for reassembly.
Oh have removed the bulkhead and engine cowlings along with the rad to gain better access to the entire chassis.
Has been a busy couple of days but progressing well.
Blog: Sammio Spyder Build here
http://sammio-spyder.blogspot.com/