[seanick]

Riveting stuff!
put the rivets in, 5mm, counter bored with a 10mm flat bit.
[IMG][/IMG]

Despite tapering the GRP before gluing the shell on, there was still a bit of a dip in the join, so I put two more layers of chopped strand mat over the joint to fill the valley.
[IMG][/IMG]

Did the same to both sides, then applied one skim of filler over the lot with an 8" filling knife.
[IMG][/IMG]
That looks better!

I also glassed the b pillar joint as I had removed the original drop down bits of. GRP in my many 'fittings' of the shell.
Finally decided to fill the rear number plate recess. Since I have narrowed the body this is 4" too narrow fir a std number plate so rather than filling I laminated in 4 layers of GTP, and will gel coat over that.